2023/12/22 08:58

Three welding techniques for stainless steel welded pipes

Stainless steel welded pipe technology--Argon arc welding

Stainless steel welded pipe requires deep weld penetration, does not contain oxide inclusions, the heat affected zone is as small as possible, tungsten inert gas shielded argon arc welding has a better adaptability, high weld quality, weld penetration performance is good, and its products are widely used in the chemical industry, the nuclear industry, and food and other industries.

Welding speed is not high is the shortcomings of argon arc welding, in order to improve the welding speed, generally using three electrode torch argon arc welding, welding steel pipe wall thickness S ≥ 2mm, welding speed than a single torch to improve 3-4 times, welding quality can also be improved. Argon arc welding and plasma welding can be combined to weld a larger wall thickness of the steel pipe, in addition, in the argon gas about 5-10% of hydrogen, and then the use of high-frequency pulsed welding power supply, can also improve the welding speed.

Stainless steel welded pipe process technology - high frequency welding

Frequency welding has a higher power source power, for different materials, OD wall thickness of the steel pipe can achieve a high welding speed. Compared with argon arc welding, it is more than 10 times its welding speed. Therefore, the production of general-purpose stainless steel pipe has a high productivity.

 Because of the high speed of high frequency welding, the removal of burrs in the welded pipe brings difficulties. At present, high-frequency welded stainless steel pipe is not yet acceptable for the chemical and nuclear industries, which is one of the reasons. From the welding material, high-frequency welding can weld various types of austenitic stainless steel pipe. At the same time, the development of new steel grades and advances in molding welding methods have also successfully welded ferritic stainless steel AISI409 and other steel grades.


Pneumatic valve working principle and failure analysis

The so-called pneumatic valve, specifically refers to the cylinder as an actuator, compressed air as a power source to realize the drive of the valve, in order to achieve the switch to regulate.

Advantages and disadvantages of several types of valves

Advantages and disadvantages of several types of valves

Plumbing fittings classification method

Plumbing fittings in the elbow fittings classification: elbow fittings according to the radius of curvature to points, can be divided into long radius elbow and short radius elbow. Long radius elbow means that its radius of curvature is equal to 1.5 times the outside diameter of the pipe